Skip to content

Herbs

Watercress (Nasturtium officinale)

Grow watercress in a pot: sow into cool, saturated mix at 10–16 °C, keep it wet at all times, give it bright light and cut stems to keep it bushy.

Grow it in RootQ

At a glance
Light, PPFD
240⁠–⁠300 µmol/m²·s
Daily light, DLI
12⁠–⁠17 mol/m²·d
Light hours
14⁠–⁠16 h
Day temperature
18⁠–⁠26 °C (64⁠–⁠79 °F)
Night temperature
15⁠–⁠20 °C (59⁠–⁠68 °F)
Air humidity
50⁠–⁠70%
Watering
every day
Growing medium
Potting soil, coco coir, hydroponics (DWC), hydroponics (Kratky)

Values for the main growing period, from RootQ's knowledge base. The watering interval is a starting point: your pot, light and room shift it.

Watercress is a leafy perennial of streams and wet ground, and that decides how it behaves in a pot: it wants a mix that never dries out, a cool start and plenty of light. Treat it as the thirstiest herb on the shelf, not as a version of basil.

Seed or cutting

For watercress RootQ overrides the shared leafy-herb germination temperature. The group's range is 18–24 °C; for watercress the knowledge base uses 10–16 °C (50–61 °F), following Utah State University Extension, which describes seed germinating in cool (50–60 °F), wet conditions. Sow into saturated mix, press the seed in and cover it lightly. The germination stage in the shared model lasts 3 to 14 days, and the seedling stage about 10 to 21 days, ending with the first true leaves.

A cutting skips both. Root a soft stem tip in wet mix: Utah State University Extension notes that stem cuttings root quickly where the soil stays very wet; in RootQ a cutting enters at the harvestable stage.

Light

RootQ has no watercress-specific light target and uses its shared leafy-herb range, not a measurement made on watercress. For a plant you cut from that is a PPFD of 240–300 µmol/⁠m²/s over a 14–16 hour day, a daily light integral (DLI) of 12–17 mol/⁠m²/day; seedlings run at a PPFD of 200–260 and a DLI of 10–15.

Measure a window with a lux meter or phone app and convert the reading with the lux to PPFD calculator. The DLI calculator turns a lamp's PPFD and hours into a daily dose, and the grow light calculator gives the lamp power for your shelf.

Water and substrate

This is where watercress differs most. RootQ halves the standard herb watering interval (a water factor of 0.5 on a two-day base), so the schedule asks for a daily check; the factor is a direction taken from the sources' "saturated", not a measured figure. Keep the mix wet through the whole depth of the pot. A pot standing in a saucer with a layer of water is a common way to keep it that way, but change that water so it does not turn stagnant.

Use a loose potting mix with a pH of 6.5–7.5, which is the watercress override of the shared 6–7. Pot size matters because small pots dry quickly; the pot volume calculator gives the litres and a watering amount for the pot you have. Feed about every three weeks while you are cutting.

Temperature and humidity

The shared range for plants in harvest is 18–26 °C (64–79 °F) by day and 15–20 °C (59–68 °F) at night, with humidity of 50–70%. That is RootQ's range for the leafy-herb group, not a watercress optimum; the knowledge base holds a watercress-specific temperature only for germination. Keep the pot off radiators and out of a hot summer window, where the mix dries fastest.

Harvesting and pruning

Cut stems back to a few centimetres above the mix with clean scissors; the plant regrows from the nodes. RootQ schedules a cut about every 10 days. Take from the top and sides, do not strip all the stems in one go, and pinch back long trailing stems so the clump stays dense.

Flowering

In RootQ's cycle the harvest stage ends with bolting, when the plant puts up flower stalks, and the plant then goes back to harvest. A stem that has flowered is growing for seed, not for leaves, so cut it back to a lower node and leaf growth resumes.

Common problems

  • Wilting and crisp leaf edges: the mix dried out. Water thoroughly and move to a daily check.
  • Pale, stretched growth: too little light.
  • Yellowing in a stagnant saucer: the water standing in it has gone stale. Replace it.
  • Seedlings collapsing: damping off from sowing too thickly and poor airflow.

RootQ's knowledge base has no ASPCA or NC State toxicity record for watercress, so the page makes no claim about pets.

Questions

How to grow watercress indoors?

Sow into a pot of constantly wet mix with a pH of 6.5–7.5, keep it cool while it germinates and give it bright light. RootQ uses a germination temperature of 10–16 °C for watercress, from Utah State University Extension.

How often to water watercress?

Far more often than other herbs. RootQ halves the standard two-day herb watering interval for watercress, which comes out at a daily check, and the mix should never dry out.

Why does watercress wilt on a windowsill?

Usually the mix has dried out. Watercress is a plant of wet ground; keep the pot saturated and away from radiators and hot glass, where it dries fastest.

Can watercress be grown from cuttings?

Yes. Utah State University Extension says watercress is easily propagated by stem cuttings; root a soft stem tip in wet mix. In RootQ a cutting enters at the harvestable stage, so it skips germination and the seedling stage.

Is watercress toxic to cats and dogs?

RootQ's knowledge base has no toxicity record for watercress from the ASPCA or NC State, so we cannot give an answer. Check with a vet if your pet chews it.

Sources

Figures come from RootQ's knowledge base and these sources. Editorial review is pending.

Plan its care in RootQ

Choose this plant in the app and RootQ builds its care plan: light, watering and reminders for every stage.

Grow it in RootQ

Guides for this plant

Calculators for this plant