Vietnamese coriander, or rau ram, is a creeping tropical perennial with narrow leaves; botanists also know it as Polygonum odoratum. It belongs to the knotweed family, not to the carrot family of true coriander, and does not behave like it: it is a warm, damp-loving plant that spreads by stems and roots easily from cuttings. It is a good herb for a bright, warm room and a poor one for a cold windowsill.
Seed or cutting
RootQ files it under its leafy-herb group, and the numbers on this page are that group's shared ranges, not measurements made on Vietnamese coriander alone; the knowledge base has no species override. Cuttings are the practical start. Take a soft stem tip with a few nodes, strip the lower leaves and stand it in a glass of water until roots form, or push it into a moist mix. In RootQ a cutting enters at the harvestable stage, so you skip germination and the seedling stage. A rooted piece from an existing plant works the same way.
If you do sow, the group asks for a soil temperature of 18–24 °C (64–75 °F) and allows 3 to 14 days for germination, followed by a seedling stage of about 10 to 21 days.
Light
RootQ has no light target specific to this plant. The shared leafy-herb range for a plant you cut from is a PPFD of 240–300 µmol/m²/s over a 14–16 hour day, which gives a daily light integral (DLI) of 12–17 mol/m²/day (PPFD × hours × 0.0036). Seedlings run at a PPFD of 200–260 and a DLI of 10–15. Too little light shows as long gaps between leaves and a thin, trailing plant.
Measure a window with a lux meter or phone app and convert the reading with the lux to PPFD calculator. With a lamp, the DLI calculator turns its PPFD and hours into a daily dose, and the grow light calculator gives the lamp power for your shelf.
Watering and substrate
Use a light mix with a pH of 6–7 and a pot with drainage holes. RootQ's herb schedule starts from a check every two days and adapts to the pot, the light and the room. Because the plant comes from warm, wet habitats, keep the mix evenly moist and do not let it dry out completely; water thoroughly and empty the saucer so the roots do not sit in water. Feed about every three weeks while you are cutting. A trailing plant outgrows its pot; the pot volume calculator gives the litres and a watering amount when you move up a size.
Temperature and humidity
The shared range in harvest is 18–26 °C (64–79 °F) by day and 15–20 °C (59–68 °F) at night, with humidity of 50–70%. The Missouri Botanical Garden calls it a tender perennial, winter-hardy only in frost-free areas, so keep it off cold glass and away from open windows in winter.
Harvesting and pruning
Cut stems back to just above a node so that the plant branches instead of trailing in one long line. RootQ schedules a cut about every 10 days. Cut from the top and sides, leave several leaves on every stem and do not take everything at once. Pieces you cut off can be rooted as new plants.
Flowering
RootQ's leafy-herb cycle ends the harvest stage with bolting, and the plant then returns to harvest. Vietnamese coriander is a perennial, so flowering does not end it, but stems that flower grow less leaf. Cut a flowering stem back to a lower node.
Common problems
- Long gaps between leaves, thin growth: too little light.
- Leaf edges turning crisp, wilting: the mix dried out, or the air is too dry and hot.
- Yellowing in a saucer full of water: roots sitting in water. Empty the saucer.
- Blackened or limp leaves after a cold night: chilling from glass or a draught.
- Cuttings that rot instead of rooting: the water was stale or the stem was too old. Change the water and use soft tips.
RootQ's knowledge base has no ASPCA or NC State toxicity record for Vietnamese coriander, so the page makes no claim about pets.