Skip to content

№ 04 · climate

VPD calculator

Air and leaf vapour pressure deficit from temperature and humidity, compared with the target of the stage.

To the inputs

Input

°C
25 °C
%
60 %
°C
1.5 °C

Air VPD

1.27 kPa

3.17 × (1 − 60 / 100) = 1.27

SVP at 25 °C
3.17 kPa
Leaf VPD
0.99 kPa

Air VPD compared with the stage target

Peppers, vegetative

Slightly above the range

Formula

SVP(T) = 0.6108 × exp(17.27 × T / (T + 237.3))

VPD air = SVP(T air) × (1 − RH / 100)

VPD leaf = SVP(T leaf) − SVP(T air) × RH / 100

T leaf = T air − d

Warm air holds more water vapour than cool air. VPD is how far the air is from saturation: the higher it is, the faster leaves lose water. Under LEDs leaves often run 1⁠–⁠2 °C cooler than the air; under HPS they can be warmer. The calculator assumes 1.5 °C unless you measure it.

SVP
saturation vapour pressure at a temperature, kPa
T air
air temperature, °C
T leaf
leaf temperature, °C
RH
relative humidity, %
d
how much cooler the leaf is than the air, °C; 1.5 by default

Reference

Peppers, vegetative
0.80–1.20 kPa

The stage target from the RootQ knowledge base: peppers in vegetative growth. It has no VPD targets for leafy herbs or foliage plants yet.

Example

A pepper plant in vegetative growth, in air at 25 °C and 65 % relative humidity. Its air VPD:

3.17 × (1 − 65 / 100) = 1.11

1.11 kPa is inside the 0.80–1.20 kPa target of vegetative peppers.

Opens RootQ with this calculation: sign in by email and pick your plant.

Save for my plant

Questions

What is a good VPD?

It depends on the plant and its stage. In the RootQ knowledge base, peppers in vegetative growth target 0.80–1.20 kPa. Below the range the air is too humid and leaves transpire slowly; above it the air is too dry and the plant starts to close its stomata.

Air VPD or leaf VPD?

This page reads air VPD against the target, because it needs only a thermometer and a hygrometer. Leaf VPD is closer to what the plant feels, but it needs the leaf temperature; measure it with an infrared thermometer. Under LEDs leaves often run 1⁠–⁠2 °C cooler than the air; under HPS they can be warmer. The calculator assumes 1.5 °C unless you measure it.

How do I lower or raise VPD?

To lower it, raise the humidity or lower the temperature; to raise it, do the opposite. Change one thing at a time and let the air settle before you measure again.

Plants this matters for