Skip to content

Peppers

Bishop's Crown

Grow Bishop's Crown pepper at home: germination in 7–28 days, 90–105 days to maturity, 5,000–30,000 SHU, plants of 120–150 cm. Light and fruit set.

Grow it in RootQ

At a glance
Light, PPFD
400⁠–⁠520 µmol/m²·s
Daily light, DLI
20⁠–⁠30 mol/m²·d
Light hours
14⁠–⁠16 h
Day temperature
24⁠–⁠29 °C (75⁠–⁠84 °F)
Night temperature
18⁠–⁠22 °C (64⁠–⁠72 °F)
Air humidity
55⁠–⁠70%
Watering
every 3 days
Growing medium
Potting soil, coco coir, hydroponics (DWC), hydroponics (Kratky)
Heat
5,000⁠–⁠30,000 SHU
Germination
7⁠–⁠28 days
Days to maturity, from transplant
90⁠–⁠105 days
Plant height
120⁠–⁠150 cm

Values for the main growing period, from RootQ's knowledge base. The watering interval is a starting point: your pot, light and room shift it.

Bishop's Crown, also sold as Bishop Crown and Christmas Bell, has three-winged pods shaped like a bishop's mitre, with a fruity flavour and medium heat of 5,000–30,000 SHU. It is one of the tallest peppers on RootQ, 120–150 cm, and matures 90–105 days after transplant. Indoors, everything starts with height.

Headroom before anything else

Add up the pot, 150 cm of plant and the gap the lamp needs above the canopy, and check it against your ceiling, shelf or tent before you sow. A plant this tall shades its own lower branches and grows into a lamp that cannot be raised. Top it early to widen the frame, and keep raising the lamp as it grows.

The grow light calculator gives lamp power in watts for your area and target PPFD; it does not give a hanging height, so measure that with a light meter or the lamp's PPFD map. The light targets themselves are the standard pepper ones: a PPFD of 240–300 µmol/⁠m²/s for 14–16 hours and a target DLI of 12–17 mol/⁠m²/day for seedlings, then 400–520 µmol/⁠m²/s and a DLI of 20–30 over 14–16 hours from vegetative growth to fruiting. The DLI calculator shows what your measured PPFD and hours add up to in a day.

Which species?

PepperScale lists Bishop's Crown as Capsicum baccatum and Reimer Seeds as annuum. RootQ follows PepperScale. In practice it changes little: the light, temperature and feeding targets below are the same for both species, and the 7–28 day germination window used for baccatum also covers the quicker annuum one.

Germination and timing

Seeds come up in 7–28 days. Keep the substrate at 27–32 °C, moist but not soaked, and check every day.

Maturity is 90–105 days from transplant; Reimer Seeds lists 90 days, and 105 is a planning allowance. With germination and the seedling stage (21–35 days) in front, the first ripe pod comes roughly 118–168 days after sowing. It opens a harvest window of 14–28 days for the rest of the crop; check every three days and pick fully coloured pods. On a plant this size, look into the inner and lower branches too.

Temperature and humidity

Seedlings like 24–27 °C by day and 18–21 °C at night at 65–75% humidity; vegetative plants 24–29 °C and 18–22 °C at 55–70%. From flowering the day range is 21–29 °C with nights at 18–22 °C, and humidity drops to 50–65%, then 50–60% in fruit. If leaves curl, check the room with the VPD calculator; the targets are 0.8–1.2 kPa in vegetative growth and 1–1.4 kPa in flower.

Pot, watering and feeding

Pot up when vegetative growth starts and top the plant about 14 days later. A tall plant in a small pot dries out quickly, and repeated wilting drops buds, so choose the final pot with the pot volume calculator, which gives litres and a watering amount.

In soil, water about every 3 days as a seedling and in vegetative growth and every 2 days in flower and fruit, adjusting by pot weight. Feed at quarter strength on days 14 and 28 of the seedling stage, a week into vegetative growth and every 14 days after that; soil pH 6–6.8. In coco, fertigate daily and measure runoff weekly: EC 1–1.4 for seedlings, 1.4–2 in vegetative growth, 1.8–2.4 in flower and 2–2.6 in fruit, at pH 5.8–6.2 up to flowering and 5.8–6.3 after.

Pollination and fruit set

Once the first flowers open, tap the stem or hold an electric toothbrush against it once a day, ideally mid-morning. Above about 32 °C by day pollination fails and flowers drop; on a tall plant the top is closest to the lamp, so measure the temperature there. A few early drops are normal; if they carry on for more than a week, check temperature, then watering, then light.

Handling

With heat up to 30,000 SHU, the hottest pods irritate skin and eyes. Wear gloves to cut or deseed them, keep your hands away from your face, and wash hands and tools afterwards.

Overwintering

After harvest the plant can rest 60–120 days. Cutting it back also brings a 150 cm plant down to a size that fits a cool spot. Keep it at 13–18 °C by day and 12–15 °C at night with 100–200 µmol/⁠m²/s for 10–12 hours at 40–60% humidity. In soil, water about every 14 days; in coco, fertigate every 7 days.

Questions

How long does Bishop's Crown take to germinate?

Between 7 and 28 days with the substrate at 27–32 °C. Check the tray daily and keep the substrate evenly moist.

How hot is Bishop's Crown?

About 5,000–30,000 Scoville heat units (SHU), a medium heat with a wide range. A jalapeño is 2,500–8,000 SHU.

How tall does Bishop's Crown grow?

120–150 cm, one of the tallest ranges among the peppers on RootQ. Measure the headroom over your pot before you sow, because the lamp needs to stay above the canopy.

Is Bishop's Crown a baccatum or an annuum?

The sources disagree. PepperScale lists Capsicum baccatum, which is how RootQ files it, and Reimer Seeds lists annuum. The care targets on this page are the same for both species.

How long until ripe pods?

90–105 days from transplant. Reimer Seeds lists 90 days; 105 is a planning allowance. Germination and the 21–35 day seedling stage come before that.

Sources

Figures come from RootQ's knowledge base and these sources. Editorial review is pending.

Plan its care in RootQ

Choose this plant in the app and RootQ builds its care plan: light, watering and reminders for every stage.

Grow it in RootQ

Guides for this plant

Calculators for this plant